INTENSIVE BRUSH SPARKING

causers

solutions

oval collector

service the collector (grating or grinding)

spiked brushes in holder

clean the holder

dirt and oil between lamellas

clean segments, filtrate air, close the bearings

low brush preasure

increase preasure

brush was not run in properly

run in brush, again

riding insulation

run in insulation and service the collector

wrong holder possition

adjust holder position

wrong brush possition

set up neutral axle

machine vibrations

decrease vibrations if it is possibly, increase holder preasure, change material grade and brush construction (set up rubber schock absorber on brush top)

wrong material grade

contact us, please

RAPID COLLECTOR OR SLIPRING WEARING

causers

solutions

ununiform current distribution; brush track overload

adjust holder preasure to the same level; take more burnish material grade

dusty cooling air

mount cooling air filter

low load tranches

turn off some brushes or change material grade to lower current

agressive gasses and vapours

clear cooling air should be inserted and take more burnish material grade

collector or slipring tranches due to oil film

use covered bearings and decrease oil vapour influence

anode effect material wearing (DC sliprings)

periodical polarity changing

zavlačenje bakra (videti L10)

zbog složenosti uzroka potrebno je da nas kontaktirate